Gecko G540 Stepper Drive REV-8

US$249.00 Ex GST
Save: 7% off

US$273.90 Inc GST

 This is the latest REV-8 G540 drive

The G540 is a complete 4-axis Stepper Drive system which plugs directly into your computer via the parallel port and to your motors through DB9 connectors. It contains four G250 drives, internal breakout board and a hard anodized aluminum case.


      G540 Specifications:

      - Four 10-Microstep motor drives
      - 0 to 3.5A rated phase current
      - 18VDC to 50VDC supply voltage
      - Mid-band resonance compensation
      - Auto standby current (70% current)
      - Short-circuit protected
      - Optoisolation on all LPT signal pins
      - Two 1A at 0 to 50VDC rated outputs
      - Four SPST to GND inputs
      - FAULT indicator LED,signal to PC
      - POWER indicator LED
      - I-SET resistor on motor connector
      - TRIM adjust for motor smoothness
      - Panel mount (5.7” by2.4” hole dim.)

      - Anodized aluminum package
      - No heatsink needed below 40C ambient

      - Easy to service, removable drives
      - Modular PCB design with no internal wires          

           - 10kHz watchdog timer (charge pump)
           - Optoisolated analog output for a VFD drive

      - Conservative ratings, premium components
           - Comes with four backshells and four DB9 solder cup connectors

G540 Manual Rev 8



Add to Cart:

  • Model: G540
  • Shipping Weight: 0.33kgs

Gecko G540 Stepper Drive REV-8

Gecko G540 Stepper Drive REV-8

Sorry we ran out!

Fill out this form and we will let you know when it comes back in stock

wabusiness template