Testimonials

Hi Peter,

I am really excited with the new TurboTaig board and Mach2. I have never, in the 2 1/2 years that I have own the mill, seen the mill run so smoothly. It is almost scary to watch it run today compared to what I had before.

I pushed the speed up 25 ipm exact cut, running a 60 degree cutter through micarta to cut a 3-D plate of 'Madonna and Child' by Rembrandt. I would have lost one of the axis before if I had tried to cut it faster than 17 ipm.

If you need a testimonial for your web site, use this or let me know.

Great Job!

Best Regards,
Chris Klindt

Peter,

I couldn't be happier with my new setup. The faceplate and engraving job
ran my mill for almost three straight hours, and ran thousands of lines of
code without a single missed step or glitch. For the first time in well
over a year I felt comfortable turning my back on the mill and letting it
do its thing. I can't wait to build the limit switches, spindle encoder,
relay box, and digitizing probe.

There's a magazine over here called the Home Shop Machinist. It's
published by Village Press. They occasionally run review articles. If
you don't mind, I'd like to write a review for your board. I really only
have good things to say about it.

Thanks again,

Tom Benidict